Correlation between pH and molar iron/ligand ratio during ciprofloxacin degradation by photo-Fenton process: Identification of the main transformation products

Ciprofloxacin has been determined with high frequency in studies involving environmental waters matrixes. However, no study evaluating the correlation between the initial pH and molar iron/organic ligand ratio has been published. This paper describes the degradation of the antibiotic ciprofloxacin by the photo-Fenton process using different sources of iron (Fe2+, Fe3+ and Fe3+-citrate and Fe3+-oxalate, named FeCit and FeOx, respectively) and molar iron/organic ligand ratios at initial pH values of 2.5 and 6.5. The best results at initial pH 2.5 were achieved using FeCit and FeOx at molar iron/organic ligand ratios of 1:1 and 1:3 respectively, when the ciprofloxacin concentration reached values below the quantitation limit of the HPLC after 20 min of treatment. However, at initial pH 6.5, improvements in the results (15% for FeCit, and 46% for FeOx) were achieved by increasing the molar iron/organic ligand ratios to 1:4 (FeCit) and 1:9 (FeOx), respectively. Three transformation products, (C17H19FN3O4, m/z 348; C17H21FN3O5, m/z 366; and C13H12FN2O3, m/z 263) of ciprofloxacin degradation were identified, one of them not yet being reported in the literature (C17H21FN3O5, m/z 366). Their formation and degradation was monitored and the initial steps of their formation and degradation were proposed. The results show that the piperazine ring is more susceptible to hydroxyl radical attack than the quinolone ring, which persists in the intermediates identified. Therefore, this process can be a good alternative for the treatment of this type of pollutant at near-neutral conditions. (C) 2018 Elsevier Ltd. All rights reserved.