Matrix effect in case of purification of oily waters by membrane separation combined with pre-ozonation

In the present study, oil in water emulsions (c(oil) = 100 ppm; d(oil droplets) < 2 m) was purified with ozonation followed by microfiltration using polyethersulfone (PES) membrane (d(pore) = 0.2 mu m). The effects of pre-ozonation on membrane microfiltration were investigated in detail both in case of ultrapure and model groundwater matrices, applying different durations (0, 5, 10, and 20 min) of pre-ozonation. Simultaneously, the effects of added inorganic water components on the combined method were investigated. Size distribution of oil droplets, zeta potentials, fluxes, and purification efficiencies were measured and fouling mechanisms were described in all cases. It was found that the matrix significantly affected the size distribution and adherence ability of oil droplets onto the membrane surface, therefore fouling mechanisms also were strongly dependent on the matrix. In case of low salt concentration, the total resistance was caused mainly by reversible resistance, which could be significantly reduced (eliminated) by pre-ozonation. In case of model groundwater matrix, nearly twice higher total resistance was measured, and irreversible resistance was dominant, because of the higher adhesion ability of the oil droplets onto the membrane surface. In this case, pre-ozonation resulted in much lower irreversible, but higher reversible resistance. Increased duration of pre-ozonation raised the total resistance and reduced the elimination efficiency (due to fragmented oil droplets and water soluble oxidation by-products) in both cases, therefore short pre-ozonation can be recommended both from economic and performance aspects.