The α → ω Transformation in Titanium-Cobalt Alloys under High-Pressure Torsion

The α→ω and β→ω phase transformations in Ti–Fe alloys under high-pressure torsion

(2018) A.R. Kilmametov et al.   ACTA MATERIALIA

Transformations of α' martensite in Ti–Fe alloys under high pressure torsion

(2017) A. Kilmametov et al.   SCRIPTA MATERIALIA

Development of an interatomic potential for the simulation of defects, plasticity, and phase transformations in titanium

(2016) M. I. Mendelev et al.   JOURNAL OF CHEMICAL PHYSICS

Vacancy-mediated ω-assisted α-phase formation mechanism in titanium–molybdenum alloy

(2015) Sung-Hwan Kim et al.   ACTA MATERIALIA

Phase Transformations in Ti-Fe Alloys Induced by High-Pressure Torsion

(2015) B. B. Straumal et al.   ADVANCED ENGINEERING MATERIALS

Importance of coordination number and bond length in titanium revealed by electronic structure investigations

(2015) Liang-Feng Huang et al.   PHYSICA STATUS SOLIDI B-BASIC SOLID STATE PHYSICS

Phase transitions in metallic alloys driven by the high pressure torsion

(2013) B. Straumal et al.   Archives of Civil and Mechanical Engineering

Phase transitions during high pressure torsion of CuCo alloys

(2013) B.B. Straumal et al.   MATERIALS LETTERS

Influence of impurities on phase stability of martensites in titanium

(2012) J.H. Dai et al.   PHILOSOPHICAL MAGAZINE

Structure and Properties of Nanograined Fe-C Alloys after Severe Plastic Deformation

(2011) Boris B. Straumal et al.   ADVANCED ENGINEERING MATERIALS

Pseudopotential errors in titanium

(2011) Bengt E. Tegner et al.   COMPUTATIONAL MATERIALS SCIENCE

Effect of pressure on the electronic structure of hcp Titanium

(2011) Jafari et al.   Condensed Matter Physics

Deformation-driven formation of equilibrium phases in the Cu–Ni alloys

(2011) B. B. Straumal et al.   JOURNAL OF MATERIALS SCIENCE

Synthesis of non-equilibrium phases in immiscible metals mechanically mixed by high pressure torsion

(2011) Tatsuya Miyazaki et al.   JOURNAL OF MATERIALS SCIENCE

Transmission electron microscopy investigation of boundaries between amorphous “grains” in Ni50Nb20Y30 alloy

(2011) A. A. Mazilkin et al.   JOURNAL OF MATERIALS SCIENCE

Influence of the thermal treatment on the deformation-induced precipitation of a hypoeutectic Al–7wt% Si casting alloy deformed by high-pressure torsion

(2010) C.M. Cepeda-Jiménez et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Fityk: a general-purpose peak fitting program

(2010) Marcin Wojdyr   JOURNAL OF APPLIED CRYSTALLOGRAPHY

Processing Pure Ti by High-Pressure Torsion in Wide Ranges of Pressures and Strain

(2009) Kaveh Edalati et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Thermal evolution and grain boundary phase transformations in severely deformed nanograined Al–Zn alloys

(2008) B. Straumal et al.   ACTA MATERIALIA

Evidence of α → ω phase transition in titanium after high pressure torsion

(2008) Yulia Ivanisenko et al.   International Journal of Materials Research

Experimental constraints on the phase diagram of titanium metal

(2008) Jianzhong Zhang et al.   JOURNAL OF PHYSICS AND CHEMISTRY OF SOLIDS

Fe–C nanograined alloys obtained by high-pressure torsion: Structure and magnetic properties

(2008) B.B. Straumal et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Classical potential describes martensitic phase transformations between theα,β, andωtitanium phases

(2008) R. G. Hennig et al.   PHYSICAL REVIEW B

Severe plastic deformation induced nanocrystallization of melt-spun Al85Y8Ni5Co2 amorphous alloy

(2007) P. Henits et al.   JOURNAL OF ALLOYS AND COMPOUNDS