期刊
MICROMACHINES
卷 8, 期 11, 页码 -出版社
MDPI AG
DOI: 10.3390/mi8110332
关键词
thin-walled double side; freeform surface; filling method
类别
资金
- National Science and Technology Major Project of the Ministry of Science and Technology of China [2017ZX04013001]
The machining of thin-walled double side freeform component has many challenges in terms of the geometrical complexity, high-requirement accuracy, and especially low stiffness. This paper surveys the filling method during the milling processes of thin-walled double side freeform component. Firstly, the DEFORM-3D was used to analyze and calculate the surface residual stress which provides a theoretical basis for parameters selection of the rough milling process, and the optimal milling parameters were obtained by the Taguchi method. Residual stress measurements have been carried out to verify the simulation results. The results show the difference between simulation and experimental data is less than 15%. Secondly, semi-finishing parameters and finishing process parameters were determined by equal error step length and step distance method. Thirdly, two machining experiments were conducted with and without paraffin filling, and the accuracy was measured by coordinate measurement machine. The results shown that the PV values are 25.16 m and 20.34 m for the concave and convex surface, and the corresponding RMS values are 13.75 m and 11.93 m in the first milling experiment. The PV values have improved to 8.53 m and 7.12 m, and RMS values have improved to 2.45 m and 3.05 m by the filled method applied.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据