标题
A review on conversion techniques of liquid fuel from waste plastic materials
作者
关键词
-
出版物
INTERNATIONAL JOURNAL OF ENERGY RESEARCH
Volume 41, Issue 11, Pages 1534-1552
出版商
Wiley
发表日期
2017-01-28
DOI
10.1002/er.3720
参考文献
相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。- Performance and emission characteristics of diesel fuel produced from waste plastic oil obtained by catalytic pyrolysis of waste polypropylene
- (2016) Achyut K. Panda et al. Energy Sources Part A-Recovery Utilization and Environmental Effects
- Performance of biodiesel/higher alcohols blends in a diesel engine
- (2016) Nadir Yilmaz et al. INTERNATIONAL JOURNAL OF ENERGY RESEARCH
- Catalytic co-pyrolysis of Eichhornia Crassipes biomaѕѕ and polyethylene using waste Fe and CaCO3catalysts
- (2016) Hussain Gulab et al. INTERNATIONAL JOURNAL OF ENERGY RESEARCH
- Production of fuel by co-pyrolysis of Makarwal coal and waste polypropylene through a hybrid heating system of convection and microwaves
- (2016) Khadim Hussain et al. INTERNATIONAL JOURNAL OF ENERGY RESEARCH
- Investigation on performance, emission and combustion characteristics of variable compression engine fuelled with diesel, waste plastics oil blends
- (2016) S. Ananthakumar et al. Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Experimental investigation of performance, emission and combustion characteristics of waste plastic pyrolysis oil blended with diethyl ether used as fuel for diesel engine
- (2015) J. Devaraj et al. ENERGY
- A detailed study of combustion characteristics of a DI diesel engine using waste plastic oil and its blends
- (2015) Viswanath K. Kaimal et al. ENERGY CONVERSION AND MANAGEMENT
- An experimental study on usage of plastic oil and B20 algae biodiesel blend as substitute fuel to diesel engine
- (2015) D. K. Ramesha et al. ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH
- Waste to liquid fuels: potency, progress and challenges
- (2015) Ahmad Galadima et al. INTERNATIONAL JOURNAL OF ENERGY RESEARCH
- Energy recovery from co-gasification of waste polyethylene and polyethylene terephthalate blends
- (2013) P. Kannan et al. COMPUTERS & FLUIDS
- Performance and emission analysis of blends of waste plastic oil obtained by catalytic pyrolysis of waste HDPE with diesel in a CI engine
- (2013) Sachin Kumar et al. ENERGY CONVERSION AND MANAGEMENT
- Conversion of mixed plastic wastes in a dual fluidized bed steam gasifier
- (2013) V. Wilk et al. FUEL
- Efficient disposal of waste polyolefins through microwave assisted pyrolysis
- (2013) Andrea Undri et al. FUEL
- Mechanical, pyrolysis, and combustion characterization of briquetted coal fines with municipal solid waste plastic (MSW) binders
- (2013) M.M. Massaro et al. FUEL
- The influence of reaction parameters on characteristics of pyrolysis oils from waste high impact polystyrene and acrylonitrile–butadiene–styrene using a fluidized bed reactor
- (2013) Su-Hwa Jung et al. FUEL PROCESSING TECHNOLOGY
- Conversion of low density polyethylene into fuel through co-processing with vacuum gas oil in a fluid catalytic cracking riser reactor
- (2013) Andrew O. Odjo et al. FUEL PROCESSING TECHNOLOGY
- Catalytic efficiency of some novel nanostructured heterogeneous solid catalysts in pyrolysis of HDPE
- (2013) Imtiaz Ahmad et al. POLYMER DEGRADATION AND STABILITY
- Recycling of waste plastics into fuels. LDPE conversion in FCC
- (2012) Francisco J. Passamonti et al. APPLIED CATALYSIS B-ENVIRONMENTAL
- Experimental analysis of biofuel as an alternative fuel for diesel engines
- (2012) Edwin Geo Varuvel et al. APPLIED ENERGY
- Catalytic conversion of waste high-density polyethylene into useful hydrocarbons
- (2012) M. Rasul Jan et al. FUEL
- Experimental investigation of performance, emission and combustion characteristics of an indirect injection multi-cylinder CI engine fuelled by blends of de-inking sludge pyrolysis oil with biodiesel
- (2012) A.K. Hossain et al. FUEL
- Liquid hydrocarbon fuels from fish oil industrial residues by catalytic cracking
- (2012) Nadia Mrad et al. INTERNATIONAL JOURNAL OF ENERGY RESEARCH
- Non-isothermal pyrolysis of the mixtures of waste automobile lubricating oil and polystyrene in a stirred batch reactor
- (2012) Seung-Soo Kim et al. RENEWABLE ENERGY
- Catalytic pyrolysis of plastic wastes with two different types of catalysts: ZSM-5 zeolite and Red Mud
- (2011) A. López et al. APPLIED CATALYSIS B-ENVIRONMENTAL
- Hydrogen-rich gas production from waste plastics by pyrolysis and low-temperature steam reforming over a ruthenium catalyst
- (2011) Tomoaki Namioka et al. APPLIED ENERGY
- Influence of time and temperature on pyrolysis of plastic wastes in a semi-batch reactor
- (2011) A. López et al. CHEMICAL ENGINEERING JOURNAL
- Catalytic coprocessing of coal and petroleum residues with waste plastics to produce transportation fuels
- (2011) Mohammad Farhat Ali et al. FUEL PROCESSING TECHNOLOGY
- Direct injection diesel engine performance, emission, and combustion characteristics using diesel fuel, nonedible honne oil methyl ester, and blends with diesel fuel
- (2011) B. K. Venkanna et al. INTERNATIONAL JOURNAL OF ENERGY RESEARCH
- Thermal and catalytic degradation of polyethylene wastes in the presence of silica gel, 5A molecular sieve and activated carbon
- (2011) Yovana Sander González et al. JOURNAL OF HAZARDOUS MATERIALS
- Water injection effects on the performance and emission characteristics of a CI engine operating with biodiesel
- (2011) B. Tesfa et al. RENEWABLE ENERGY
- Pyrolysis of municipal plastic wastes II: Influence of raw material composition under catalytic conditions
- (2011) A. López et al. WASTE MANAGEMENT
- Characterisation and effect of using waste plastic oil and diesel fuel blends in compression ignition engine
- (2010) M. Mani et al. ENERGY
- Response surface methodology optimization applied to rubber tyre and plastic wastes thermal conversion
- (2010) Miguel Miranda et al. FUEL
- Pyrolysis–gasification of plastics, mixed plastics and real-world plastic waste with and without Ni–Mg–Al catalyst
- (2010) Chunfei Wu et al. FUEL
- Catalytic degradation of waste high-density polyethylene into fuel products using BaCO3 as a catalyst
- (2010) M. Rasul Jan et al. FUEL PROCESSING TECHNOLOGY
- Hydrocarbon fuels produced by catalytic pyrolysis of hospital plastic wastes in a fluidizing cracking process
- (2010) Hung-Ta Lin et al. FUEL PROCESSING TECHNOLOGY
- Low temperature conversion of plastic waste into light hydrocarbons
- (2010) Sajid Hussain Shah et al. JOURNAL OF HAZARDOUS MATERIALS
- Performance, emission and combustion characteristics of a DI diesel engine using waste plastic oil
- (2009) M. Mani et al. APPLIED THERMAL ENGINEERING
- Recovery of plastic wastes from dumpsite as refuse-derived fuel and its utilization in small gasification system
- (2009) Chart Chiemchaisri et al. BIORESOURCE TECHNOLOGY
- Influence of injection timing on performance, emission and combustion characteristics of a DI diesel engine running on waste plastic oil
- (2009) M. Mani et al. ENERGY
- An experimental investigation on a DI diesel engine using waste plastic oil with exhaust gas recirculation
- (2009) M. Mani et al. FUEL
- Pyrolysis of mixed plastics for the recovery of useful products
- (2009) Mohammad Nahid Siddiqui et al. FUEL PROCESSING TECHNOLOGY
- Fuels by pyrolysis of waste plastics from agricultural and packaging sectors in a pilot scale reactor
- (2009) N. Miskolczi et al. FUEL PROCESSING TECHNOLOGY
- Conversion of hazardous plastic wastes into useful chemical products
- (2009) Mohammad Nahid Siddiqui JOURNAL OF HAZARDOUS MATERIALS
- Production of valuable hydrocarbons by catalytic degradation of a mixture of post-consumer plastic waste in a fluidized-bed reactor
- (2009) Yeuh-Hui Lin POLYMER DEGRADATION AND STABILITY
- Thermolysis of waste plastics to liquid fuelA suitable method for plastic waste management and manufacture of value added products—A world prospective
- (2009) Achyut K. Panda et al. RENEWABLE & SUSTAINABLE ENERGY REVIEWS
- Influence of distillation on performance, emission, and combustion of a DI diesel engine, using tyre pyrolysis oil diesel blends
- (2008) Sivalingam Murugan et al. Thermal Science
- The use of tyre pyrolysis oil in diesel engines
- (2008) S. Murugan et al. WASTE MANAGEMENT
- Performance, emission and combustion studies of a DI diesel engine using Distilled Tyre pyrolysis oil-diesel blends
- (2007) S. Murugan et al. FUEL PROCESSING TECHNOLOGY
- Mechanistic implications of plastic degradation
- (2007) Baljit Singh et al. POLYMER DEGRADATION AND STABILITY
Discover Peeref hubs
Discuss science. Find collaborators. Network.
Join a conversationPublish scientific posters with Peeref
Peeref publishes scientific posters from all research disciplines. Our Diamond Open Access policy means free access to content and no publication fees for authors.
Learn More