Hard turning behavior improvement using NSGA-II and PSO-NN hybrid model

Analysis and optimization of hard turning operation using cubic boron nitride tool

(2014) Khaider Bouacha et al.   INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS

Evolutionary techniques in optimizing machining parameters: Review and recent applications (2007–2011)

(2012) Norfadzlan Yusup et al.   EXPERT SYSTEMS WITH APPLICATIONS

Particle swarm optimization technique for determining optimal machining parameters of different work piece materials in turning operation

(2010) S. Bharathi Raja et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Multi-objective optimization of cutting parameters in turning process using differential evolution and non-dominated sorting genetic algorithm-II approaches

(2009) S. H. Yang et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Statistical analysis of surface roughness and cutting forces using response surface methodology in hard turning of AISI 52100 bearing steel with CBN tool

(2009) Khaider Bouacha et al.   INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS

Analysis of Machinability During Hard Turning of Cold Work Tool Steel (Type: AISI D2)

(2009) V. N. Gaitonde et al.   MATERIALS AND MANUFACTURING PROCESSES

Multi-objective optimization for the periodic operation of the naphtha pyrolysis process using a new parallel hybrid algorithm combining NSGA-II with SQP

(2008) Xiaodan Gao et al.   COMPUTERS & CHEMICAL ENGINEERING

Modelling of residual stresses in the shot peened material C-1020 by artificial neural network

(2008) Cetin Karataş et al.   EXPERT SYSTEMS WITH APPLICATIONS

Machinability investigations in hard turning of AISI D2 cold work tool steel with conventional and wiper ceramic inserts

(2008) V.N. Gaitonde et al.   INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS

Experimental investigations of cutting parameters influence on cutting forces and surface roughness in finish hard turning of MDN250 steel

(2008) D.I. Lalwani et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Investigation of tool wear and cutting force in cryogenic machining using design of experiments

(2007) K.V.B.S. Kalyan Kumar et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY