Investigation on mixed-mode II-III fracture of the sandstone by using eccentric cracked disk
出版年份 2021 全文链接
标题
Investigation on mixed-mode II-III fracture of the sandstone by using eccentric cracked disk
作者
关键词
Mixed-mode II-III fracture, Eccentric cracked disk (ECD) specimen, Stress intensity factor, Numerical and experimental study
出版物
THEORETICAL AND APPLIED FRACTURE MECHANICS
Volume 115, Issue -, Pages 103077
出版商
Elsevier BV
发表日期
2021-08-14
DOI
10.1016/j.tafmec.2021.103077
参考文献
相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。- Analysis of Mixed-Mode I/II/III Fracture Toughness Based on a Three-Point Bending Sandstone Specimen with an Inclined Crack
- (2021) Xin Pan et al. Applied Sciences-Basel
- Three-dimensional physical model experiment of mining-induced deformation and failure characteristics of roof and floor in deep underground coal seams
- (2021) Jun Lu et al. PROCESS SAFETY AND ENVIRONMENTAL PROTECTION
- Stress intensity factors for a centrally cracked Brazilian disk under non-uniformly distributed pressure
- (2021) Huaizi Tang et al. THEORETICAL AND APPLIED FRACTURE MECHANICS
- Impact of the intermediate stress component in a plastic potential function on rock mass stability around a sequentially excavated large underground cavity
- (2020) Atsushi Sainoki et al. INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES
- On the comparison of two mixed-mode I + III fracture test specimens
- (2020) A. Bahmani et al. ENGINEERING FRACTURE MECHANICS
- A novel test system for mixed mode-I/II/III fracture tests – Part 1: Modeling and numerical analyses
- (2019) A.O. Ayhan et al. ENGINEERING FRACTURE MECHANICS
- A novel test system for mixed mode-I/II/III fracture tests – Part 2: Experiments and criterion development
- (2019) O. Demir et al. ENGINEERING FRACTURE MECHANICS
- Sub-sized short bend beam configuration for the study of mixed-mode fracture
- (2019) M.R.M. Aliha et al. ENGINEERING FRACTURE MECHANICS
- On the use of edge cracked short bend beam specimen for PMMA fracture toughness testing under mixed-mode I/II
- (2019) S.S. Mousavi et al. POLYMER TESTING
- A novel test configuration designed for investigating mixed mode II/III fracture
- (2018) Behnam Saboori et al. ENGINEERING FRACTURE MECHANICS
- A novel fixture for mixed mode I/II/III fracture testing of brittle materials
- (2018) Afshin Zeinedini FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES
- Rock Fracture Toughness Study Under Mixed Mode I/III Loading
- (2017) M. R. M. Aliha et al. ROCK MECHANICS AND ROCK ENGINEERING
- Investigation of fracture toughness for a polycrystalline graphite under combined tensile-tear deformation
- (2017) A. Bahmani et al. THEORETICAL AND APPLIED FRACTURE MECHANICS
- Study on fracture behavior of HMA mixtures under mixed mode I/III loading
- (2016) S. Pirmohammad et al. ENGINEERING FRACTURE MECHANICS
- A novel test specimen for investigating the mixed mode I+III fracture toughness of hot mix asphalt composites – Experimental and theoretical study
- (2016) M.R.M. Aliha et al. INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES
- Modified maximum tangential stress criterion for fracture behavior of zirconia/veneer interfaces
- (2016) M.M. Mirsayar et al. Journal of the Mechanical Behavior of Biomedical Materials
- Numerical analysis of a new mixed mode I/III fracture test specimen
- (2015) M.R.M. Aliha et al. ENGINEERING FRACTURE MECHANICS
- Experimental study on the fracture toughness of rust stone under mixed mode loading condition
- (2015) W. Hua et al. MATERIALS RESEARCH INNOVATIONS
- Determination of mode III fracture toughness for different materials using a new designed test configuration
- (2015) M.R.M. Aliha et al. MATERIALS & DESIGN
- Effects of temperature and confining pressure on mixed-mode (I–II) and mode II fracture toughness of Kimachi sandstone
- (2014) Takahiro Funatsu et al. INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES
- The effects of thickness and Poisson’s ratio on 3D mixed-mode fracture
- (2012) M.R.M. Aliha et al. ENGINEERING FRACTURE MECHANICS
- Application of Cracked Triangular Specimen Subjected to Three-Point Bending for Investigating Fracture Behavior of Rock Materials
- (2012) M. R. M. Aliha et al. ROCK MECHANICS AND ROCK ENGINEERING
- Geometry and size effects on fracture trajectory in a limestone rock under mixed mode loading
- (2010) M.R.M. Aliha et al. ENGINEERING FRACTURE MECHANICS
- Criterion for initiation of cracks under mixed-mode I + III loading
- (2010) Bisen Lin et al. INTERNATIONAL JOURNAL OF FRACTURE
- Theoretical analysis of the effects of relative crack length and loading angle on the experimental results for cracked Brazilian disk testing
- (2007) Shiming Dong ENGINEERING FRACTURE MECHANICS
Publish scientific posters with Peeref
Peeref publishes scientific posters from all research disciplines. Our Diamond Open Access policy means free access to content and no publication fees for authors.
Learn MoreBecome a Peeref-certified reviewer
The Peeref Institute provides free reviewer training that teaches the core competencies of the academic peer review process.
Get Started