标题
Effect of surface geometry on laser powder bed fusion defects
作者
关键词
Additive manufacturing, Laser powder bed fusion, AlSi10Mg, Surface roughness, Defects, Triply periodic minimal surfaces, 3D printing
出版物
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY
Volume 296, Issue -, Pages 117179
出版商
Elsevier BV
发表日期
2021-04-23
DOI
10.1016/j.jmatprotec.2021.117179
参考文献
相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。- Internal surface roughness enhancement of parts made by laser powder-bed fusion additive manufacturing
- (2020) Usman Ali et al. VACUUM
- Geometrical metrology for metal additive manufacturing
- (2019) R.K. Leach et al. CIRP ANNALS-MANUFACTURING TECHNOLOGY
- Fatigue life prediction for AlSi10Mg components produced by selective laser melting
- (2019) Ming Tang et al. INTERNATIONAL JOURNAL OF FATIGUE
- Effects of defects on mechanical properties in metal additive manufacturing: A review focusing on X-ray tomography insights
- (2019) Anton du Plessis et al. MATERIALS & DESIGN
- Effect of geometry on the mechanical properties of Ti-6Al-4V Gyroid structures fabricated via SLM: A numerical study
- (2019) Eric Yang et al. MATERIALS & DESIGN
- Metal Alloys for Fusion-Based Additive Manufacturing
- (2018) Duyao Zhang et al. ADVANCED ENGINEERING MATERIALS
- Roughness modeling of AlSi10Mg parts fabricated by selective laser melting
- (2017) Alberto Boschetto et al. JOURNAL OF MATERIALS PROCESSING TECHNOLOGY
- Additive manufacturing of metals
- (2016) Dirk Herzog et al. ACTA MATERIALIA
- Analytical relationships for prediction of the mechanical properties of additively manufactured porous biomaterials
- (2016) Amir Abbas Zadpoor et al. JOURNAL OF BIOMEDICAL MATERIALS RESEARCH PART A
- Quantification and characterisation of porosity in selectively laser melted Al–Si10–Mg using X-ray computed tomography
- (2016) I. Maskery et al. MATERIALS CHARACTERIZATION
- Mechanical behavior of additive manufactured, powder-bed laser-fused materials
- (2016) Todd M. Mower et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- X-ray computed tomography for additive manufacturing: a review
- (2016) A Thompson et al. MEASUREMENT SCIENCE and TECHNOLOGY
- Surface texture metrology for metal additive manufacturing: a review
- (2016) A. Townsend et al. PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY
- Selective laser melting (SLM) of AlSi12Mg lattice structures
- (2016) Martin Leary et al. MATERIALS & DESIGN
- Surface texture measurement for additive manufacturing
- (2015) Andrew Triantaphyllou et al. Surface Topography-Metrology and Properties
- Additive Manufacturing: Making Imagination the Major Limitation
- (2014) Yuwei Zhai et al. JOM
- Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powder
- (2012) Lore Thijs et al. ACTA MATERIALIA
Find Funding. Review Successful Grants.
Explore over 25,000 new funding opportunities and over 6,000,000 successful grants.
ExploreBecome a Peeref-certified reviewer
The Peeref Institute provides free reviewer training that teaches the core competencies of the academic peer review process.
Get Started