Correlation between residual stresses and the tribological behaviour of Inconel 625 coatings

Advances in Corrosion-Resistant Thermal Spray Coatings for Renewable Energy Power Plants. Part I: Effect of Composition and Microstructure

(2019) Esmaeil Sadeghi et al.   JOURNAL OF THERMAL SPRAY TECHNOLOGY

Influence of coating thickness on residual stress and adhesion-strength of cold-sprayed Inconel 718 coatings

(2018) R. Singh et al.   SURFACE & COATINGS TECHNOLOGY

Optimization of HVOF Cr 3 C 2 NiCr coating for increased fatigue performance

(2016) T. Varis et al.   SURFACE & COATINGS TECHNOLOGY

Effect of Residual Stress on the Wear Resistance of Thermal Spray Coatings

(2015) W. Luo et al.   JOURNAL OF THERMAL SPRAY TECHNOLOGY

Residual stress development in cold sprayed Al, Cu and Ti coatings

(2013) T. Suhonen et al.   ACTA MATERIALIA

HVOF-Deposited WCCoCr as Replacement for Hard Cr in Landing Gear Actuators

(2011) A. Agüero et al.   JOURNAL OF THERMAL SPRAY TECHNOLOGY

FIB assisted study of plasma sprayed splat–substrate interfaces: NiAl–stainless steel and alumina–NiAl combinations

(2010) G. Bolelli et al.   SURFACE & COATINGS TECHNOLOGY

Influence of Surface Roughness on the Transfer Film Formation and Frictional Behavior of TiC/a-C Nanocomposite Coatings

(2010) K. P. Shaha et al.   TRIBOLOGY LETTERS

Fatigue strength of HVOF sprayed Cr3C2–25NiCr and WC-10Ni on AISI 4340 steel

(2008) R.C. Souza et al.   SURFACE & COATINGS TECHNOLOGY