4.7 Article

Cosolvent-Driven Interfacial Polymerization for Superior Separation Performance of Polyurea-Based Pervaporation Membrane

期刊

POLYMERS
卷 13, 期 8, 页码 -

出版社

MDPI
DOI: 10.3390/polym13081179

关键词

thin-film composite membranes; pervaporation; interfacial polymerization; polyurea; membrane separation

资金

  1. Opening Project of Material Corrosion and Protection Key Laboratory of Sichuan Province [2019CL05]
  2. Opening Project of Sichuan Province Key Laboratory of Process Equipment and Control, Sichuan University of Science and Engineering [2019RC05]
  3. Ministry of Science and Technology of Taiwan [MOST 109-2221-E-197-009]

向作者/读者索取更多资源

A thin-film composite (TFC) polyurea membrane was fabricated for the dehydration of an aqueous tetrahydrofuran (THF) solution through interfacial polymerization, with addition of ethanol as a cosolvent yielding the highest separation performance.
A thin-film composite (TFC) polyurea membrane was fabricated for the dehydration of an aqueous tetrahydrofuran (THF) solution through interfacial polymerization, wherein polyethyleneimine (a water-soluble amine monomer) and m-xylene diisocyanate (an oil-soluble diisocyanate monomer) were reacted on the surface of a modified polyacrylonitrile (mPAN) substrate. Cosolvents were used to tailor the membrane properties and increase the membrane permeation flux. Four types of alcohols that differed in the number of carbon (methanol, ethanol, isopropanol, and tert-butanol) were added as cosolvents, serving as swelling agents, to the aqueous-phase monomer solution, and their effect on the membrane properties and pervaporation separation was discussed. Attenuated total reflection Fourier transform infrared spectroscopy confirmed the formation of a polyurea layer on mPAN. Field emission scanning electron microscopy and surface water contact angle analysis indicated no change in the membrane morphology and hydrophilicity, respectively, despite the addition of cosolvents for interfacial polymerization. The TFC membrane produced when ethanol was the cosolvent exhibited the highest separation performance (permeation flux = 1006 +/- 103 g center dot m(-2)center dot h(-1); water concentration in permeate = 98.8 +/- 0.3 wt.%) for an aqueous feed solution containing 90 wt.% THF at 25 degrees C. During the membrane formation, ethanol caused the polyurea layer to loosen and to acquire a certain degree of cross-linking. The optimal fabrication conditions were as follows: 10 wt.% ethanol as cosolvent; membrane curing temperature = 50 degrees C; membrane curing time = 30 min.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.7
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据