Melt pool evolution on inclined NV E690 steel plates during laser direct metal deposition

Thermal fluid dynamics of liquid bridge transfer in laser wire deposition 3D printing

(2019) Renzhi Hu et al.   SCIENCE AND TECHNOLOGY OF WELDING AND JOINING

Online Stress Measurement During Laser-aided Metallic Additive Manufacturing

(2019) Yi Lu et al.   Scientific Reports

Computational fluid dynamic simulation of gravity and pressure effects in laser metal deposition for potential additive manufacturing in space

(2019) Heng Gu et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Investigation of humping phenomenon for the multi-directional robotic wire and arc additive manufacturing

(2019) Lei Yuan et al.   ROBOTICS AND COMPUTER-INTEGRATED MANUFACTURING

Development of thick copper claddings on SS316L steel for In-vessel components of fusion reactors and copper-cast iron canisters

(2018) Surinder Singh et al.   FUSION ENGINEERING AND DESIGN

Numerical and experimental investigation of thermal field and residual stress in laser-MIG hybrid welded NV E690 steel plates

(2018) G.F. Sun et al.   Journal of Manufacturing Processes

Real-Time Composition Monitoring Using Support Vector Regression of Laser-Induced Plasma for Laser Additive Manufacturing

(2017) Lijun Song et al.   IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS

Modeling of thermal behavior and mass transport in multi-layer laser additive manufacturing of Ni-based alloy on cast iron

(2017) Zhengtao Gan et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Comparison of microstructure and mechanical properties of ultra-narrow gap laser and gas-metal-arc welded S960 high strength steel

(2017) Wei Guo et al.   OPTICS AND LASERS IN ENGINEERING

Melt-pool motion, temperature variation and dendritic morphology of Inconel 718 during pulsed- and continuous-wave laser additive manufacturing: A comparative study

(2017) Simeng Li et al.   MATERIALS & DESIGN

The influence of the substrate-inclined angle on the section size of laser cladding layers based on robot with the inside-beam powder feeding

(2016) Gangxian Zhu et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Anisotropic tensile behavior of Ti–6Al–4V components fabricated with directed energy deposition additive manufacturing

(2015) Beth E. Carroll et al.   ACTA MATERIALIA

Calculation of laser absorption by metal powders in additive manufacturing

(2015) C. D. Boley et al.   APPLIED OPTICS

Evolution of solidification texture during additive manufacturing

(2015) H. L. Wei et al.   Scientific Reports

Additive Manufacturing: Current State, Future Potential, Gaps and Needs, and Recommendations

(2014) Yong Huang et al.   JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME

Microstructure and mechanical behavior of commercial purity Ti/Ti–6Al–2Zr–1Mo–1V structurally graded material fabricated by laser additive manufacturing

(2013) Yao-Jian Liang et al.   SCRIPTA MATERIALIA

Laser rapid manufacturing on vertical surfaces: Analytical and experimental studies

(2013) C.P. Paul et al.   SURFACE & COATINGS TECHNOLOGY

A camera based feedback control strategy for the laser cladding process

(2012) J.T. Hofman et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Control of melt pool temperature and deposition height during direct metal deposition process

(2011) Lijun Song et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Effects of Melt Pool Variables and Process Parameters in Laser Direct Metal Deposition of Aerospace Alloys

(2010) Kamran Shah et al.   MATERIALS AND MANUFACTURING PROCESSES

Theoretical aspects of fibre laser cutting

(2009) A Mahrle et al.   JOURNAL OF PHYSICS D-APPLIED PHYSICS