Unusual strain-induced martensite and absence of conventional grain refinement in twinning induced plasticity high-entropy alloy processed by high-pressure torsion

The tension-compression asymmetry of martensite phase transformation in a metastable Fe40Co20Cr20Mn10Ni10 high-entropy alloy

(2020) Xinglong An et al.   Science China-Materials

High-entropy alloys with heterogeneous microstructure: Processing and mechanical properties

(2020) Praveen Sathiyamoorthi et al.   PROGRESS IN MATERIALS SCIENCE

A powder-metallurgy-based fabrication route towards achieving high tensile strength with ultra-high ductility in high-entropy alloy

(2020) Peyman Asghari-Rad et al.   SCRIPTA MATERIALIA

Deformation-driven bidirectional transformation promotes bulk nanostructure formation in a metastable interstitial high entropy alloy

(2019) Jing Su et al.   ACTA MATERIALIA

Fully Recrystallized Al0.5CoCrFeNi High-Entropy Alloy Strengthened by Nanoscale Precipitates

(2019) Haoxue Yang et al.   METALS AND MATERIALS INTERNATIONAL

Effect of Initial Grain Size on Deformation Mechanism during High‐Pressure Torsion in V 10 Cr 15 Mn 5 Fe 35 Co 10 Ni 25 High‐Entropy Alloy

(2019) Peyman Asghari-Rad et al.   ADVANCED ENGINEERING MATERIALS

Development and Microstructural Characterization of a New Wrought High Entropy Superalloy

(2019) Ahad Shafiee et al.   METALS AND MATERIALS INTERNATIONAL

Microstructure Stability and Its Influence on the Mechanical Properties of CrMnFeCoNiAl0.25 High Entropy Alloy

(2019) Lijing Lin et al.   METALS AND MATERIALS INTERNATIONAL

Dynamic shear deformation of a CrCoNi medium-entropy alloy with heterogeneous grain structures

(2018) Yan Ma et al.   ACTA MATERIALIA

Twinning in metastable high-entropy alloys

(2018) Shuo Huang et al.   Nature Communications

Cryogenic-deformation-induced phase transformation in an FeCoCrNi high-entropy alloy

(2018) Qingyun Lin et al.   Materials Research Letters

Structural evolutions of metallic materials processed by severe plastic deformation

(2018) Yang Cao et al.   MATERIALS SCIENCE & ENGINEERING R-REPORTS

Annealing-induced hardening in high-pressure torsion processed CoCrNi medium entropy alloy

(2018) S. Praveen et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Ultra-high tensile strength nanocrystalline CoCrNi equi-atomic medium entropy alloy processed by high-pressure torsion

(2018) S. Praveen et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Plastic Deformation Behavior of 40Fe–25Ni–15Cr–10Co–10V High-Entropy Alloy for Cryogenic Applications

(2018) Min Ji Jang et al.   METALS AND MATERIALS INTERNATIONAL

Hot Deformation Behavior of V Micro-Alloyed TWIP Steel During Hot Compression

(2018) Hojun Gwon et al.   METALS AND MATERIALS INTERNATIONAL

Enhancing strength and strain hardenability via deformation twinning in fcc-based high entropy alloys reinforced with intermetallic compounds

(2018) Deep Choudhuri et al.   ACTA MATERIALIA

Effect of stacking faults on the ductility of Fe-18Mn-1.5Al-0.6C twinning-induced plasticity steel at low temperatures

(2017) Joon Yoo et al.   SCRIPTA MATERIALIA

Metastable high-entropy dual-phase alloys overcome the strength–ductility trade-off

(2016) Zhiming Li et al.   NATURE

Exceptional damage-tolerance of a medium-entropy alloy CrCoNi at cryogenic temperatures

(2016) Bernd Gludovatz et al.   Nature Communications

Design of a twinning-induced plasticity high entropy alloy

(2015) Y. Deng et al.   ACTA MATERIALIA

Significance of grain boundaries and stacking faults on hydrogen storage properties of Mg 2 Ni intermetallics processed by high-pressure torsion

(2015) Toshifumi Hongo et al.   ACTA MATERIALIA

Formation of epsilon martensite by high-pressure torsion in a TRIP steel

(2015) Roberto B. Figueiredo et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Martensitic Phase Transformation and Deformation Behavior of Fe-Mn-C-Al Twinning-Induced Plasticity Steel during High-Pressure Torsion

(2014) Kun Yan et al.   ADVANCED ENGINEERING MATERIALS

Microstructure and mechanical response of single-crystalline high-manganese austenitic steels under high-pressure torsion: The effect of stacking-fault energy

(2014) E.G. Astafurova et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

A fracture-resistant high-entropy alloy for cryogenic applications

(2014) B. Gludovatz et al.   SCIENCE

The critical role of grain orientation and applied stress in nanoscale twinning

(2014) Rodney J. McCabe et al.   Nature Communications

Mechanism of activation of TiFe intermetallics for hydrogen storage by severe plastic deformation using high-pressure torsion

(2013) Kaveh Edalati et al.   APPLIED PHYSICS LETTERS

Applied stress controls the production of nano-twins in coarse-grained metals

(2012) Y. Cao et al.   APPLIED PHYSICS LETTERS

Processing a twinning-induced plasticity steel by high-pressure torsion

(2012) Mariana S. Matoso et al.   SCRIPTA MATERIALIA

The role of stacking faults and twin boundaries in grain refinement of a Cu–Zn alloy processed by high-pressure torsion

(2010) Y.B. Wang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

The effect of grain size and grain orientation on deformation twinning in a Fe–22wt.% Mn–0.6wt.% C TWIP steel

(2010) I. Gutierrez-Urrutia et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Derivation and Variation in Composition-Dependent Stacking Fault Energy Maps Based on Subregular Solution Model in High-Manganese Steels

(2009) A. Saeed-Akbari et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Using high-pressure torsion for metal processing: Fundamentals and applications

(2008) A ZHILYAEV et al.   PROGRESS IN MATERIALS SCIENCE