Kinetics and Isotherm Modeling for the Treatment of Rubber Processing Effluent Using Iron (II) Sulphate Waste as a Coagulant

There is increasing concern to determine an alternative coagulant for treating industrial effluent with minimal environmental impact and operational cost. In this study, iron (II) sulphate heptahydrate (FeSO4 center dot 7H(2)O) waste, an industrial byproduct from a titanium oxide processing industry, was used as a coagulant for the removal of ammonia (NH3), chemical oxygen demand (COD), biochemical oxygen demand (BOD), and suspended solid (SS) from secondary rubber processing effluent (SRPE). The highest percentage removal of BOD, COD, SS, and NH(3)achieved was approximately 97%, 99%, 98%, and 95%, respectively, at pH 5.0, coagulant dose of 1 g/L, coagulation time of 60 min, sedimentation time of 60 min, and at an elevated temperature of 70 degrees C. The best described adsorption isotherm model was found to be the Brunauer-Emmett-Teller (BET) model, indicated that the FeSO4 center dot 7H(2)O adsorption took placed on the surface of iron hydroxide precipitates with multilayer formation and random distribution. The kinetics analysis showed that the adsorption mechanism was well fitted with the pseudo-second-order kinetic model. The findings of the present study show that the FeSO4 center dot 7H(2)O waste has the potential to be used as a coagulant for the treatment of industrial effluents, including the secondary rubber processing effluent.