Microstructure, mechanical and corrosion properties of cryorolled-AA5052 at various solution treatment temperatures

Characterization of Microstructure, Mechanical Properties and Formability of Cryorolled AA5083 Alloy Sheets

(2018) Fitsum Feyissa et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Effect of Initial Microstructure on Properties of Cryorolled Al 5052 Alloy Subjected to Different Annealing Treatment Temperatures

(2018) N. M. Anas et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Corrosion behavior of ultrafine-grained AA2024 aluminum alloy produced by cryorolling

(2017) P. Laxman Mani Kanta et al.   International Journal of Minerals Metallurgy and Materials

Cryorolling and warm forming of AA6061 aluminum alloy sheets

(2017) D. Raja Satish et al.   MATERIALS AND MANUFACTURING PROCESSES

Mechanical and tribological behavior of severely plastic deformed Al6061 at cryogenic temperatures

(2017) M. Abbasi-Baharanchi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Influence of Initial Microstructure on Microstructural Stability and Mechanical Behavior of Cryorolled A356 Alloy Subjected to Annealing

(2017) R. J. Immanuel et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Studies on Aging and Corrosion Properties of Cryorolled Al–Zn–Mg–Cu (AA7075) Alloy

(2017) K. Gopala Krishna et al.   TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS

Effect of cryo groove rolling followed by warm rolling (CGW) on the mechanical properties of 5052 Al alloy

(2016) K. K. Yogesha et al.   MATERIALS AND MANUFACTURING PROCESSES

Microstructural evolution and mechanical properties of low SFE Cu-Al alloys processed by cryorolling followed by short-annealing

(2016) S.M. Dasharath et al.   MATERIALS & DESIGN

Deep-cryogenic-treatment-induced phase transformation in the Al-Zn-Mg-Cu alloy

(2015) Chun-mei Li et al.   International Journal of Minerals Metallurgy and Materials

Precipitation phenomena, thermal stability and grain growth kinetics in an ultra-fine grained Al 2014 alloy after annealing treatment

(2015) A. Dhal et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Laser cladding of Inconel 625 wire for corrosion protection

(2015) T.E. Abioye et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Study on cryorolled Al–Cu alloy using X-ray diffraction line profile analysis and evaluation of strengthening mechanisms

(2013) N. Naga Krishna et al.   MATERIALS & DESIGN

Mechanical properties of Al–Mg–Si alloy sheets produced using asymmetric cryorolling and ageing treatment

(2013) Hai-liang Yu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Grain size distribution effects on the corrosion behaviour of materials

(2012) Srikant Gollapudi   CORROSION SCIENCE

Nanostructured aluminium alloys produced by severe plastic deformation: New horizons in development

(2012) I. Sabirov et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of ageing on microstructure and mechanical properties of bulk, cryorolled, and room temperature rolled Al 7075 alloy

(2011) Sushanta Kumar Panigrahi et al.   JOURNAL OF ALLOYS AND COMPOUNDS

The Portevin–Le Chatelier effect: a review of experimental findings

(2011) Ahmet Yilmaz   SCIENCE AND TECHNOLOGY OF ADVANCED MATERIALS

Development of ultrafine-grained Al 6063 alloy by cryorolling with the optimized initial heat treatment conditions

(2010) Sushanta Kumar Panigrahi et al.   MATERIALS & DESIGN