Mechanical characterization of 3D printed, non-planar lattice structures under quasi-static cyclic loading

Purpose While additive manufacturing via melt-extrusion of plastics has been around for more than several decades, its application to complex geometries has been hampered by the discretization of parts into planar layers. This requires wasted support material and introduces anisotropic weaknesses due to poor layer-to-layer adhesion. Curved-layer manufacturing has been gaining attention recently, with increasing potential to fabricate complex, low-weight structures, such as mechanical metamaterials. This paper aims to study the fabrication and mechanical characterization of non-planar lattice structures under cyclic loading. Design/methodology/approach A mathematical approach to parametrize lattices onto Bezier surfaces is validated and applied here to fabricate non-planar lattice samples via curved-layer fused deposition modeling. The lattice chirality, amplitude and unit cell size were varied, and the properties of the samples under cyclic-loading were studied experimentally. Findings Overall, lattices with higher auxeticity showed less energy dissipation, attributed to their bending-deformation mechanism. Additionally, bistability was eliminated with increasing auxeticity, reinforcing the conclusion of bending-dominated behavior. The analysis presented here demonstrates that mechanical metamaterial lattices such as auxetics can be explored experimentally for complex geometries where traditional methods of comparing simple geometry to end-use designs are not applicable. Originality/value This work presents an experimental approach to study the mechanical properties of non-planar lattice structures via quasi-static cyclic loading, comparing variations across several lattice patterns including auxetic sinusoids, disrupted sinusoids and their equivalent-density quadratic patterns.