Soot Production and Radiative Heat Transfer in Opposed Flame Spread over a Polyethylene Insulated Wire in Microgravity

Flame spread over an insulated electrical wire is identified as a fire scenario in space vehicles. In such microgravity configurations, the contribution of thermal radiation from gaseous participating species and soot to the wire burning rate and flame spread is not fully understood and the present paper addresses this question both experimentally and numerically. A non-buoyant opposed-flow flame spread configuration over a nickel-chrome wire coated by Low Density PolyEthylene (LDPE) is considered with an O-2/N-2 oxidizer composed of 19% of oxygen in volume and a flow velocity of 200 mm/s. Flame spread rate, pyrolysis rate, stand-off distance, soot volume fraction, and soot temperature are experimentally determined based on optical diagnostics that capture the flame spread in parabolic flights. The numerical model uses the measured spread and pyrolysis rates as input data and solves transport equations for mass, momentum, species, energy, and soot number density and mass fraction in an axisymmetric flame-fixed coordinate system in conjunction with a simple degradation model for the LDPE and a state-of-the-art radiation model. The model considers two assumptions. First, pure ethylene results from the decomposition of LDPE and, second, an acetylene/benzene based-soot model, initially validated for C-1-C-3 hydrocarbons, can be extended with minor modifications to model soot production of LDPE. Comparisons between model predictions and experimental data in terms of flame structure and soot volume fraction support these assumptions. The major finding of this study is that radiation contributes negatively to the surface heat balance along the LDPE molten surface and the coating ahead of the molten front. This shows that the convective heat transfer from the flame is the main contribution to sustain the pyrolysis process and the flame spread is mainly ensured owing to the combined contribution of convection from flame and conduction inside the condensed phase. The maximum incident radiative flux along the molten ball is 17.5 kW/m(2) and is reached at the molten ball trailing edge whereas the radiant fraction is about 0.25. Neglecting flame self-absorption affects these values by less than 5%, showing that the optically-thin approximation is valid for this flame. In addition, soot radiation dominates the radiative heat transfer in this flame, contributing for about two-third of the total radiation. Finally, model results show that the usually-used thermally-thin assumption throughout the LDPE coating is not strictly valid.