Precipitation Strengthening in Ni–Cu Alloys Fabricated Using Wire Arc Additive Manufacturing Technology

Effects of heat accumulation on the arc characteristics and metal transfer behavior in Wire Arc Additive Manufacturing of Ti6Al4V

(2017) Bintao Wu et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Influences of deposition current and interpass temperature to the Fe3Al-based iron aluminide fabricated using wire-arc additive manufacturing process

(2016) Chen Shen et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Fabricating Superior NiAl Bronze Components through Wire Arc Additive Manufacturing

(2016) Donghong Ding et al.   Materials

Effect of arc mode in cold metal transfer process on porosity of additively manufactured Al-6.3%Cu alloy

(2014) Baoqiang Cong et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Precipitation of AlN and MnS in Low Carbon Aluminium-Killed Steel

(2012) Yin-li CHEN et al.   JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL

Effect of deposition strategy on the microstructure and mechanical properties of Inconel 625 superalloy fabricated by pulsed plasma arc deposition

(2012) F.J. Xu et al.   MATERIALS & DESIGN

Effect of Mn concentration on the kinetics of strain induced precipitation in Ti microalloyed steels

(2012) Zhenqiang Wang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Morphology investigation on direct current pulsed gas tungsten arc welded additive layer manufactured Ti6Al4V alloy

(2011) Fude Wang et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Mechanical Properties of INCONEL 718 Parts Manufactured by Shaped Metal Deposition (SMD)

(2011) Bernd Baufeld   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Deoxidation Equilibrium of Titanium in the Iron–Nickel Melts

(2010) V. Ya. Dashevskii et al.   ISIJ INTERNATIONAL

Nitride Precipitation on Particles in Fe–10mass%Ni Alloy Deoxidized with Ti, M (M=Mg, Zr and Ce) and Ti/M

(2009) Andrey V. Karasev et al.   ISIJ INTERNATIONAL