Microstructure and Properties of Novel Heat Resistant Al–Ce–Cu Alloy for Additive Manufacturing

Microstructure and properties of novel AlSi11CuMn alloy manufactured by selective laser melting

(2018) A.V. Pozdniakov et al.   MATERIALS LETTERS

Characterisation of a novel Sc and Zr modified Al–Mg alloy fabricated by selective laser melting

(2017) Yunjia Shi et al.   MATERIALS LETTERS

Microstructure and phase formation in Al–20Si–5Fe–3Cu–1Mg synthesized by selective laser melting

(2016) Pan Ma et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Determining hot cracking index of Al–Mg–Zn casting alloys calculated using effective solidification range

(2015) A. V. Pozdniakov et al.   INTERNATIONAL JOURNAL OF CAST METALS RESEARCH

Selective laser melting of AlSi10Mg alloy: Process optimisation and mechanical properties development

(2015) Noriko Read et al.   MATERIALS & DESIGN

Precipitation behavior of aluminum alloy 2139 fabricated using additive manufacturing

(2015) Craig Brice et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

A review on selective laser sintering/melting (SLS/SLM) of aluminium alloy powders: Processing, microstructure, and properties

(2015) E.O. Olakanmi et al.   PROGRESS IN MATERIALS SCIENCE

Determining hot cracking index of Al–Si–Cu–Mg casting alloys calculated using effective solidification range

(2014) A. V. Pozdniakov et al.   INTERNATIONAL JOURNAL OF CAST METALS RESEARCH

Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powder

(2012) Lore Thijs et al.   ACTA MATERIALIA

Influence of process parameters on surface roughness of aluminum parts produced by DMLS

(2012) F. Calignano et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Search for promising compositions for developing new multiphase casting alloys based on Al-Cu-Mg matrix using thermodynamic calculations and mathematic simulation

(2012) V. S. Zolotorevskii et al.   PHYSICS OF METALS AND METALLOGRAPHY

Additive manufactured AlSi10Mg samples using Selective Laser Melting (SLM): Microstructure, high cycle fatigue, and fracture behavior

(2011) Erhard Brandl et al.   MATERIALS & DESIGN