4.5 Article

Experimental investigation of the hygrothermal creep strain of wood-plastic composite lumber made from thermally modified wood

期刊

JOURNAL OF THERMOPLASTIC COMPOSITE MATERIALS
卷 33, 期 9, 页码 1248-1268

出版社

SAGE PUBLICATIONS LTD
DOI: 10.1177/0892705718820398

关键词

WPC; durability; wood; lumber; hygrothermal; creep; water immersion; DMTA; thermoplastic

资金

  1. Higher Committee for Education Development (HCED) in Iraq
  2. University of Maine research reinvestment funds (RRF) Seed Grant entitled (Development of structural wood plastic composite timber for innovative marine application)
  3. United Stated Department of Agriculture (USDA)-the Agricultural Research Service (ARS) Funding [58-0202-4-003]

向作者/读者索取更多资源

The hygrothermal effect on the short-term creep behavior of extruded thermally modified wood fiber-high-strength styrenic copolymer plastic composites (wood-plastic composites (WPCs)) was investigated on specimens preconditioned for 1 month under water immersion (distilled water (DW) and saltwater (SW)). These specimens were then tested in the same conditions for short-term creep and creep-recovery response using a submersible clamp. The short-term creep tests of WPC specimens (that are immersed in water as a function of different temperatures) have not yet been reported in previous studies. The objective of this study was to determine whether the hygrothermal creep response of WPC material evaluated through water immersion differs from the creep response published in the literature for other environmental exposure conditions. The experiments included measuring 30 min of creep and 30 min of creep recovery on the specimens immersed in SW and DW at two different levels of flexural stresses (9% and 14% of the flexural strength) and three temperature values (25, 35, and 45 degrees C). The average creep strain recovery (%) of the specimens was higher for the specimens immersed in SW during testing than the control specimens. The WPC material is considered to have a potential use in structural applications in environments where the temperature is below 45 degrees C because of the following factors: the low deformation under the short-term sustained loading, the decrease in the deformation rate with respect to the increase in load duration, maintaining the modulus of elasticity over a range of temperatures from 25 degrees C to 45 degrees C under sustained load, and the ability to recover more than 69% of the average creep strain under water immersion when the loading source is removed. The creep strain fractional increment (CSFI) of the WPC in this study under all conditions was 13% which is 86% lower than the CSFI of the WPCs reported in previous studies.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.5
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据