Experiment investigation of using wire electrochemical machining in deionized water to reduce the wire electrical discharge machining surface roughness

Experimental investigations of a hybrid machining combining wire electrical discharge machining (WEDM) and fixed abrasive wire saw

(2017) Xiaoyu Wu et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

An electrochemical discharge drilling method of small deep holes

(2017) Zheng Yang Xu et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Parametric analysis of recast layer formation in wire-cut EDM of HSLA steel

(2016) Muhammad Azam et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Influence of the WEDM process on the fatigue behavior of Inconel® 718

(2016) Izaro Ayesta et al.   INTERNATIONAL JOURNAL OF FATIGUE

Wire electrochemical machining with monodirectional traveling wire

(2015) Yongbin Zeng et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Tube electrode high-speed electrochemical discharge drilling using low-conductivity salt solution

(2015) Yan Zhang et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Transitions of micro-EDM/SEDCM/micro-ECM milling in low-resistivity deionized water

(2013) Minh Dang Nguyen et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Enhanced surface integrity and dimensional accuracy by simultaneous micro-ED/EC milling

(2012) Minh Dang Nguyen et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY

An experimental study on micro-EDM in low-resistivity deionized water using short voltage pulses

(2011) Minh Dang Nguyen et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Simultaneous micro-EDM and micro-ECM in low-resistivity deionized water

(2011) Minh Dang Nguyen et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE