A Review of Factors Affecting the Burning Behaviour of Wood for Application to Tall Timber Construction

This paper presents a review of the pyrolysis, ignition, and combustion processes associated with wood, for application in tall timber construction. The burning behaviour of wood is complex. However the processes behind pyrolysis, ignition, combustion, and extinction are generally well understood, with good agreement in the fire science literature over a wide range of experimental conditions for key parameters such as critical heat flux for ignition (12kW/m(2)+/- 2kW/m(2)) and heat of combustion (17.5MJ/kg +/- 2.5MJ/kg). These parameters are key for evaluating the risks posed by using timber as a construction material. Conversely, extinction conditions are less well defined and understood, with critical mass loss rates for extinction varying from 2.5g/m(2)s to 5g/m(2)s. A detailed meta-analysis of the fire resistance literature has shown that the rate of burning as characterised by charring rate averaged over the full test duration is observed to vary with material properties, in particular density and moisture content which induce a maximum 18% variability over the ranges expected in design. System properties are also shown to be important, with stochastic phenomena such as delamination and encapsulation failure resulting in changes to the charring rate that cannot be easily predicted. Finally, the fire exposure as defined by incident heat flux has by far the largest effect on charring rates over typical heat fluxes experienced in compartment fires. Current fire design guidance for engineered timber products is largely prescriptive, relying on fixed charring rates and zero-strength layers for structural analyses, and typically prescribing gypsum encapsulation to prevent or delay the involvement of timber in a fire. However, it is clear that the large body of scientific knowledge that exists can be used to explicitly address the fire safety issues that the use of timber introduces. However the application of this science in real buildings is identified as a key knowledge gap which if explored, will enable improved efficiencies and innovations in design.