Catalytic cracking of jatropha-derived fast pyrolysis oils with VGO and their NMR characterization

Lignocellulosic biomass-derived fast pyrolysis oils are potential second-generation bio-fuels towards the reduction of greenhouse gas (GHG) emissions and carbon foot prints. This study pertains to co-process the Jatropha-derived heavy or tar fraction of fast pyrolysis oil (FPO) with vacuum gas oil (VGO) and hydrodeoxygenated fast pyrolysis oil (HDO) with VGO in a standard refinery fluid catalytic cracking (FCC) unit. The crude fast pyrolysis oil from Jatropha curcas is produced at 530 degrees C and atmospheric pressure using a bubbling fluidized bed pyrolyzer. The heavy fraction of FPO is hydrodeoxygenated over Pd/Al2O3 catalyst into HDO in an autoclave reactor at 300 degrees C and pressure of 80 bar. Further, HDO is co-processed with petroleum-derived VGO in an advanced cracking evaluation (ACE-R) unit to convert it into refinery FCC product slate hydrocarbons at a blending ratio of 5 : 95. FPO and HDO are characterized using P-31 NMR, whereas FCC distillates, which are obtained on the co-processing of VGO with fast pyrolysis oil and HDO, are characterized using H-1 and C-13 NMR spectroscopy techniques. The P-31 NMR analysis of crude FPO and HDO indicated that hydroxyl, carboxylic and methoxy groups are reduced during the hydrodeoxygenation of FPO. The experimental results at the iso-conversion level on the co-processing of HDO with VGO indicated a higher yield of liquefied petroleum gases (LPG), while lower yields of gasoline and LCO have been observed as compared to FPO co-processing with VGO and co-processing of pure VGO. Furthermore, the results of co-processing of FPO with VGO indicated that the yields of gasoline and LCO increased from 29 to 35 wt% and 14.8 to 20.4 wt%, respectively, whereas the yields of dry gas and LPG decreased from 2.1 to 1.4 wt% and 38.8 to 23.7 wt%, respectively, for an increase in the blending ratio from 5% to 20%. Therefore, it can be concluded that the co-processing of HDO with VGO in a FCC unit would be feasible in order to achieve a higher yield of LPG.