Effects of Alloying Elements on Creep Properties of Mg-Gd-Zr Alloys

The minimum creep rate and microstructures of aged samples of Mg-Gd-Zr alloys, with and without alloying additions of Zn and/or Y, have been investigated in the present work. The creep tests were performed at 523 K (250 A degrees C) and under 80 to 120 MPa, and the microstructures before and after creep tests were characterized using scanning electron microscopy, transmission electron microscopy, and the high-angle annular dark-field imaging technique. It is found that dislocation creep predominates in the steady-state creep stage for all alloys. The Mg-2.5Gd-0.1Zr (at. pct) alloy, strengthened by the beta' precipitates, has minimum creep rates in the range 1.0 x 10(-8) to 3.8 x 10(-8) s(-1) under 80 to 120 MPa. The addition of 1.0 at. pct Zn to the Mg-2.5Gd-0.1Zr alloy reduces the 0.2 pct proof strength and increases the minimum creep rate, resulting from the formation of gamma' basal plates at the expense of beta' precipitates. The replacement of 1.0 at. pct Gd by Y in the Mg-2.5Gd-1.0Zn-0.1Zr alloy leads to a substantial reduction in the minimum creep rate, even though it does not cause much change to the 0.2 pct proof strength. The reduced minimum creep rate is attributed to a much lower diffusivity of Y atoms than Gd in the solid magnesium matrix. An increase in the Gd content from Mg-1.5Gd-1.0Y-1.0Zn-0.1Zr to Mg-2.5Gd-1.0Y-1.0Zn-0.1Zr leads to a denser distribution of precipitates, a higher 0.2 pct proof strength, and a further reduction in the minimum creep rate.