Modeling and Analysis of Surface Roughness Parameters in Drilling GFRP Composites Using Fuzzy Logic

Effect of Conventional EDM Parameters on the Micromachined Surface Roughness and Fabrication of a Hot Embossing Master Microtool

(2009) Mohammad Yeakub Ali et al.   MATERIALS AND MANUFACTURING PROCESSES

Determination of an Optimum Parametric Combination Using a Surface Roughness Prediction Model for EDM of Al2O3/SiCw/TiC Ceramic Composite

(2009) K. M. Patel* et al.   MATERIALS AND MANUFACTURING PROCESSES

Machining Performance and Optimizing Machining Parameters of Al2O3–TiC Ceramics Using EDM Based on the Taguchi Method

(2009) Yan-Cherng Lin et al.   MATERIALS AND MANUFACTURING PROCESSES

Neural Network Modeling and Particle Swarm Optimization (PSO) of Process Parameters in Pulsed Laser Micromachining of Hardened AISI H13 Steel

(2009) J. Ciurana et al.   MATERIALS AND MANUFACTURING PROCESSES

Analysis of surface roughness parameters in turning of FRP tubes by PCD tool

(2008) K. Palanikumar et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Fuzzy Rule Based Modeling of Drilling Parameters for Delamination in Drilling GFRP Composites

(2008) B. Latha et al.   JOURNAL OF REINFORCED PLASTICS AND COMPOSITES

Investigating the Tool Life, Cutting Force Components, and Surface Roughness of AISI 302 Stainless Steel Material Under Oblique Machining

(2008) A. M. El-Tamimi et al.   MATERIALS AND MANUFACTURING PROCESSES

Modeling and Analysis of Machinability Evaluation in the Wire Electrical Discharge Machining (WEDM) Process of Aluminum Oxide-Based Ceramic

(2008) Kuang-Yuan Kung et al.   MATERIALS AND MANUFACTURING PROCESSES

Fuzzy Modeling and Analysis of Machining Parameters in Machining Titanium Alloy

(2008) S. Ramesh et al.   MATERIALS AND MANUFACTURING PROCESSES

Evaluation of thrust force and surface roughness in drilling composite material using Taguchi analysis and neural network

(2007) C.C. Tsao et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY