Mechanical properties of single- and double-gated injection moulded short glass fibre reinforced PBT/PC composites

Tensile and flexural properties of single-gated (SG) and double-gated (DG) injection moulded blend of polybutylene terephthalate (PBT) and polycarbonate (PC) and its composites containing 15, 20 and 30 wt.% short glass fibres were investigated. In the DG mouldings, a weldline was formed by direct impingement of two opposing melt fronts (i.e. cold weld). It was found that tensile modulus was not affected by the weldline but flexural modulus decreased in the presence of weldline. For both specimen types, modulus increased linearly with volume fraction of fibres (phi(f)), according to the rule-of-mixtures for moduli. The weldline integrity (WIF) factor for flexural modulus decreased linearly with increasing phi(f). Results showed that tensile and flexural strengths for SG mouldings increase with increasing phi(f) in a linear manner according to the rule-of-mixtures for strengths. The presence of weldline affected both strengths in a significant way; WIF factor decreased linearly with increasing phi(f) and was independent of loading mode. It was noted also, that the overall fibre efficiency parameter for tensile modulus was independent of specimen type but for flexural modulus it was lower in the case of DG mouldings. In all cases, efficiency parameter for strength was considerably lower than for the modulus. Impact strength and fracture toughness of SG mouldings were significantly greater than for DG mouldings. Although these properties for SG mouldings increased with increasing phi(f), they decreased significantly for DG mouldings. Results showed that WIF factor for impact strength and fracture toughness decreased linearly with increasing phi(f).