The measurement of craniocervical posture: A simple method to evaluate head position

Objective: Some studies have correlated craniocervical posture (CCP) with pharyngeal airway space diameter, breathing conditions, neck pain, headache, dentofacial structures and temporomandibular disorders. Several methods have been suggested in an attempt to establish the best way of evaluating head position using teleradiographs and cephalometric analysis. The objectives of this study therefore were to describe a method of measuring the natural head position (NHP) without exposure to radiation or fixture of the cephalostat, and then to test whether there might be a simple method of reproducing this position in the cephalostat to make lateral cephalograms in the study of CCP. Methods: The sample consisted of 50 healthy children (28 females and 22 males with a mean age of 10.9 +/- 4.9 years). Each subject was asked to place their feet in a standardized positions (a 30 degrees angle between the medial border of the feet with heels together using a V-podalic stabilizer), to tilt the head backwards and forwards to a decreasing extent until a natural head balance was reached, to adopt a natural posture of the shoulders, and to allow both arms to hang free. A self-adhesive circular reflecting cutaneous marker was applied to three points to enable a better view of the landmarks: the most anterior point of the frontonasal suture (N), the auricular tragus (Tr) and the most prominent spinous process of the seventh cervical vertebra (CA An operator marked the specific anatomical points of the children's profiles with a felt-tip pen on a mirror placed to one side of the patient and fixed on the wall: the N point, the Tr point, the most inferior point of the chin in the lateral view (Me) and the deepest point on the posterior contour of the cervical lordosis. A digital body posture measuring system captured a first image of each subject in NHP (TO). Five minutes later, with the same position and orientation of the feet, the operator placed the head of the subject in the cephalostat so that the new head position coincided with the head position previously registered in the mirror and a second picture was taken (T1). After a further 5 min, the subject was asked to place himself in NHP again, similarly repositioning their own feet to check the precision of the method of positioning, and a third picture was taken (U). Three craniocervical angular measurements were taken for head posture measurement: N-Tr-Vert, determined by the extended line from the N point to the Tr point and the vertical line projected onto the image by a line (Vert); C-7-Tr-Vert, determined by the extended line from C-7 to Tr and Vert; and C-7-Tr-N, the angle between C-7-Tr line and Tr-N line. In order to determine the stability of all the measurements of head position at T-1, T-2 and T-3, a paired-sample t-test was used using an alpha of 0.05 and a power of 0.90. Results: It was found that there were no statistically significant differences in head position between the pictures at T0, T1 and T2 (N-Tr-Vert, C-7-Tr-Vert and C-7-Tr-N, P > 0.05). Conclusion: This method was a good procedure for evaluating head posture without exposure to radiation. The results also suggest that a simple and rapid method can be used to apply a craniostat to the patient when a radiograph is required without modifying the NHP. (C) 2009 Elsevier Ireland Ltd. All rights reserved.