Effect of cutting speed on surface integrity and chip morphology in high-speed machining of PM nickel-based superalloy FGH95

Evaluation of surface integrity in micro drilling process for nickel-based superalloy

(2010) Muhammad Imran et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Numerical modeling of the influence of process parameters and workpiece hardness on white layer formation in AISI 52100 steel

(2009) D. Umbrello et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

SURFACE INTEGRITY CHARACTERIZATION AND PREDICTION IN MACHINING OF HARDENED AND DIFFICULT-TO-MACHINE ALLOYS: A STATE-OF-ART RESEARCH REVIEW AND ANALYSIS

(2009) Y. B. Guo et al.   MACHINING SCIENCE AND TECHNOLOGY

Dynamics of chip formation during orthogonal cutting of titanium alloy Ti–6Al–4V

(2008) M. Cotterell et al.   CIRP ANNALS-MANUFACTURING TECHNOLOGY

The sensitivity of Ni-based superalloy to hole making operations: Influence of process parameters on subsurface damage and residual stress

(2008) J. Kwong et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

White layer formation due to phase transformation in orthogonal machining of AISI 1045 annealed steel

(2008) Sangil Han et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718

(2007) R.S. Pawade et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE